Hood & Panel Roller Rack: Part #1439

  Before assembling your Hood & Panel Roller Rack please check that you have the following parts,

                                                          Parts – Hardware  

            2 – 58” Side Rails                                                     4 – 5” Locking Casters

            2 – 34” Caster Tubes                                               4 – ½” Nuts & Lock Washers

            1 –30” Center Brace                                                 4 – 5/16” x ¾” Bolts

            8 – 5’ Padded Supports                                           8 – 5/16” Rev. Locknuts

10 – 3’6” Padded Supports

1. Start with installing the four 5” casters into the 1 ½” CASTER TUBES.  Insert the ½” stem into pre-drilled holes.  Secure with ½” lock washer & ½” nut, tighten with the ¾” wrench.  Repeat process on all four casters.
   
2. Lay out side rails (angle iron braces) with round insert tubes welded on with band molding strip facing down, and approximately 30” apart.  Note: Round insert tubes facing in.
   
3. Now take the center base tube with the flat braces on either end and line up the holes on the side rails with the center tube.  Secure with four 5/16” x ¾” bolts and 5/16” rev. locknuts. Now flip over the base right side up (with band molding up).
   
4. Next take the 1 ½” tube with installed casters and the four threaded bolts facing up and insert them through the holes on either end.  Secure with four 5/16” rev. locknuts.  The base is now complete.
   
5. Take the upright padded supports and simply insert the round insert tubes, space them out as necessary…. 8 long 5’ supports and 10 – 3’6” supports.  The Hood & Panel Roller Rack will haul and store up to 8 hoods/door shells/panels etc. in any combination.